You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
30 lines
1.2 KiB
30 lines
1.2 KiB
# demo-bode-plotter
|
|
|
|
GEX demo measuring the amplitude and phase frequency response of analog filtes.
|
|
|
|
This demo uses an external waveform generador AD9833 (on a breakout module from eBay).
|
|
It could also use the built-in DAC, but the performance is sub-optimal and the plots
|
|
obtained with it had a lot of glitches. Feel free to adjust the script to use the
|
|
internal DAC and try it.
|
|
|
|
The AD9833 is connected to SPI on pins PA4 (SS), PA5 (SCK), and PA7 (MOSI).
|
|
Pins PA1 and PA2 are used by the ADC and attach before and after the filter (DUT).
|
|
|
|
The generator has low output levels (0.65 V max). To better utilize the
|
|
input range of the ADC, I used OP213 in a non-inverting configuration
|
|
(resistors 7.5k and 2.2k), with a 10M resistor from the input to GND. This gives us gain
|
|
of around 4.4, enough to reach just under 3V.
|
|
|
|
## To run the script
|
|
|
|
- Ensure you used `git clone --recursive`, or use `git submodule init`, `git submodule update`
|
|
- Load the attached UNITS.INI file into GEX (it is intended for GEX Hub)
|
|
- Connect the external circuitry and run the script.
|
|
|
|
Dependencies - pyplot, numpy, and whatever you need to use the GEX library: typically pyusb or pyserial.
|
|
|
|
## Example outputs
|
|
|
|
|
|
|
|
|
|
|