GEX demo measuring the amplitude and phase frequency response of analog filters
Ondřej Hruška e423303906
add sallen key preset 2
10 months ago
gex @ 3a5ac05d9d added gex submodule 10 months ago
.gitignore code import 10 months ago
.gitmodules added gex submodule 10 months ago
LICENSE more info 10 months ago
README.md updated readme 10 months ago
UNITS.INI more info 10 months ago
bode1_amplitude.png updated readme 10 months ago
bode1_phase.png updated readme 10 months ago
main.py add sallen key preset 2 10 months ago

README.md

demo-bode-plotter

GEX demo measuring the amplitude and phase frequency response of analog filtes.

This demo uses an external waveform generador AD9833 (on a breakout module from eBay). It could also use the built-in DAC, but the performance is sub-optimal and the plots obtained with it had a lot of glitches. Feel free to adjust the script to use the internal DAC and try it.

The AD9833 is connected to SPI on pins PA4 (SS), PA5 (SCK), and PA7 (MOSI). Pins PA1 and PA2 are used by the ADC and attach before and after the filter (DUT).

The generator has low output levels (0.65 V max). To better utilize the input range of the ADC, I used OP213 in a non-inverting configuration (resistors 7.5k and 2.2k), with a 10M resistor from the input to GND. This gives us gain of around 4.4, enough to reach just under 3V.

To run the script

  • Ensure you used git clone --recursive, or use git submodule init, git submodule update
  • Load the attached UNITS.INI file into GEX (it is intended for GEX Hub)
  • Connect the external circuitry and run the script.

Dependencies - pyplot, numpy, and whatever you need to use the GEX library: typically pyusb or pyserial.

Example outputs

bode1_amplitude.png

bode1_phase.png