GEX demo measuring the amplitude and phase frequency response of analog filters
You can not select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
demo-bode-plotter/README.md

30 lines
1.2 KiB

# demo-bode-plotter
GEX demo measuring the amplitude and phase frequency response of analog filtes.
This demo uses an external waveform generador AD9833 (on a breakout module from eBay).
It could also use the built-in DAC, but the performance is sub-optimal and the plots
obtained with it had a lot of glitches. Feel free to adjust the script to use the
internal DAC and try it.
The AD9833 is connected to SPI on pins PA4 (SS), PA5 (SCK), and PA7 (MOSI).
Pins PA1 and PA2 are used by the ADC and attach before and after the filter (DUT).
The generator has low output levels (0.65 V max). To better utilize the
input range of the ADC, I used OP213 in a non-inverting configuration
(resistors 7.5k and 2.2k), with a 10M resistor from the input to GND. This gives us gain
of around 4.4, enough to reach just under 3V.
## To run the script
- Ensure you used `git clone --recursive`, or use `git submodule init`, `git submodule update`
- Load the attached UNITS.INI file into GEX (it is intended for GEX Hub)
- Connect the external circuitry and run the script.
Dependencies - pyplot, numpy, and whatever you need to use the GEX library: typically pyusb or pyserial.
## Example outputs
![bode1_amplitude.png](bode1_amplitude.png)
![bode1_phase.png](bode1_phase.png)