# GEX platform
# - alternate configurations defining board layout and capabilities

GEX_PLAT=F072_ZERO
#GEX_PLAT=F072_HUB
#GEX_PLAT=F072_DISCOVERY

# Disable debug UART (saves some Flash and RAM)
DISABLE_DEBUG     = 0

# Disable USB Mass Storage support 
# - significant FLASH and RAM savings, but the virtual filesystem will be
#   accessible only through the communication interface
DISABLE_MSC       = 0

# Disconnect GEX from the USB library, and connect CDC/ACM Rx directly to Tx
# - this is used during porting / USB debugging to verify the USB subsystem 
#   is configured correcctly
CDC_LOOPBACK_TEST = 0

# Enabled GEX units
# - comment out units you don't want to include in the firmware image
# - additional units have minimal impact on performance, but take up space
#   in the Flash memory; enabling all units at once might not even be possible
#   due to this limitation
# - this also lets you switch between alternate implementations
GEX_UNITS += 1wire
GEX_UNITS += adc
GEX_UNITS += dac
GEX_UNITS += din
GEX_UNITS += dout
GEX_UNITS += fcap
GEX_UNITS += i2c
GEX_UNITS += neopixel
GEX_UNITS += pwmdim
GEX_UNITS += sipo
GEX_UNITS += spi
GEX_UNITS += touch
GEX_UNITS += usart