## UNITS.INI
## GEX v0.3.1 on STM32F072-ZERO
## built May 22 2018 at 12:05:33

[UNITS]
# Create units by adding their names next to a type (e.g. DO=A,B),
# remove the same way. Reload to update the unit sections below.

# Digital output
DO=trig
# Digital input with triggers
DI=
# Neopixel RGB LED strip
NPX=
# I2C master
I2C=
# SPI master
SPI=
# Serial port
USART=
# 1-Wire master
1WIRE=
# Analog/digital converter
ADC=adc
# Shift register driver (595, 4094)
SIPO=
# Frequency and pulse measurement
FCAP=
# Capacitive touch sensing
TOUCH=
# Simple PWM output
PWMDIM=
# Two-channel analog output with waveforms
DAC=

[DO:trig@1]
# Port name
port=B
# Pins (comma separated, supports ranges)
pins=1
# Initially high pins
initial=
# Open-drain pins
open-drain=

[ADC:adc@2]
# Enabled channels, comma separated
#  0  1  2  3  4  5  6  7    8  9   10 11 12 13 14 15   16    17
# A0 A1 A2 A3 A4 A5 A6 A7   B0 B1   C0 C1 C2 C3 C4 C5   Tsens Vref
channels=0-1

# Sampling time (0-7)
sample_time=2
# Sampling frequency (Hz)
frequency=20000

# Sample buffer size
# - shared by all enabled channels
# - defines the maximum pre-trigger size (divide by # of channels)
# - captured data is sent in half-buffer chunks
# - buffer overrun aborts the data capture
buffer_size=500

# Enable continuous sampling with averaging
# Caution: This can cause DAC output glitches
averaging=N
# Exponential averaging coefficient (permil, range 0-1000 ~ 0.000-1.000)
# - used formula: y[t]=(1-k)*y[t-1]+k*u[t]
# - not available when a capture is running
avg_factor=500